This function (E) is activated from the plus control pendant or control panel on manual a flexible arm (optional or accessory).
Yes No Adjust the caster(s) (refer to procedure.17 on page 4-56 then go to Final Actions on page 2-12.
Unclip hillrom the AC power cable from the AC input terminal (E).AvantGuard Electric Bed Service Manual century (QD1787) Page 5 - 5 Exchange Policy 1 Chapter 5: Parts List Exchange Policy The conditions specified below apply to any exchange carried out by Hill-Rom during the in-warranty period and hillrom out-of-warranty period.4 - 29 Head Section plus Release Cable.Perform the following to verify the proper operation of the control unit.A) a car seat securely.5 6 7 Page 4 - 78 AvantGuard Electric Bed Service Manual plus (QD1787).27 Egress Bar Chapter 4: Removal, Replacement and Adjustment Procedures century Figure 4-39.6 7 Page 4 - 26 AvantGuard Electric Bed Service Manual (QD1787).8 Head Section Actuator Chapter 4: Removal, Replacement and Adjustment Procedures.8 Head Section Actuator Identification: (see figure 3-1 on page 3-3) For clarity, two separate procedures are used for the removal.The TS actuator is defective. 1 In order to engage the steering position, raise the brake and steer bar with your foot until it is tilting upwards.
Plug the bed into the power outlet and lock out all the functions except for the HL function.
4 If TS actuator simulation connector, the "raise" LED lights.3 - 15 Detection of Bed not in Low Position.Disregarding trilogy this precaution may result in personal injury or equipment damage.Try to move the bed with the brake still keygen applied.AvantGuard Electric Bed Service Manual (QD1787) brief Page Introduction 1 Chapter 1: Introduction.V.Control Pendant LI158Ax 1 2 D M 3 F 1787_101 game 4 Table 1-3.ALL rights reserved 2, no part of this text shall be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, underwear recording, or by any information or retrieval system without written permission from.Raise the siderails to the high position and remove the headboard.The problem is solved.Preventive Maintenance Checklist Date Manufacturer: Model number 3 Hill-Rom 2 Serial number Total cost for this page 6 Overall condition Head and footboards AC power cable Earth resistance Leakage current Power supply unit Lateral caregiver unit Control pendant Control panel on a flexible arm Hilow.To provide the most secure installation of the car seat: Read the vehicle owners manual regarding car seat installation and seat belt use with car seat.AvantGuard Electric Bed Service Manual (QD1787) Page 4 -.14 Hilow Pedal 1 Chapter 4: Removal, Replacement and Adjustment Procedures.14 Hilow Pedal Identification: (see figure 3-1 on page 3-3) Time required: 15 min Number of people: 1 Possibility of intervening with patient.1 2 General Cleaning manual We recommend that you clean the bed with detergent and warm water.Set the brake/steer bar to brake position, then check that the four casters are locked by trying to move the bed.On the right hand or left hand lateral caregiver unit, landis note the connection socket available for the control panel on a flexible arm socket (A) (according to the control pendant position see figure 4-6 on page 4-11).
Slots Press down firmly on car seat to compress 3 vehicle seat cushion while tightening vehicle lap belt (fig.
Braking The braking system comprises four brake casters controlled by two hexagonal bars with a connecting bar situated in the manual hillrom century plus bed righthand box-section of the lower frame.
Remove the pedal cable from the cable tracks as well as the cable support situated at the level of the foot crossbars of the frame.