Specifications, handedness: Right, barrel length (in.
CST Or email at the following addresses: Technical Questions, and Information Order safety Parts Warranty Information SRS-40 Manual 1 Table of Contents Safety Page safety 3 Specifications Page 4 Operation Page 5 Maintenance Page 6 Installation Page 11 Assembly Drawings Page 17 Replacement Parts Page 19 Troubleshooting.
Products must manual be installed and operated in accordance with Stellars written instructions and capacities.
FAN Compressor Assembly: Prepare the mounting location of the compressor manual by locating and drilling four (4) holes, 1/2 diameter manual as per the mounting pattern of the air compressor base.Before Start-Up Inspect unit for any visible signs of damage.Never use manual plastic pipe or improperly rated metal pipe.Refill separator receiver with oil up to maximum, then close oil fill.Drain the condensation regularly when the compressor unit is cold prior to startup.Check ground wire and fan switch/relay.Safety instructions AND instruction manual, warning.Tighten cap back into place and unit is ready to be put into service.It does not cover depreciation manual or damage caused by normal wear and tear, accident, mishap, untrained operators, or improper or unintended use.Improper OR unsafe use of this power tool can result in death or serious bodily injury! Failure to warkeys adhere to the iris instructions could result in property damage or even serious bodily injury to the keygen operator windows or others close to the compressor.
These precautions are given here for your safety.
Restriction in control line (dirt/ice).
This manual is not binding.Insufficient hydraulic system pressure or flow.Do not attempt to adjust or disable the compressors air pressure relief valve.less than 20 biofuel content.Any excess oil runs out the fill.Advertencia, la utilización, inapropiadeligrosa de esta herramienta eléctrica code puede resultar en lesiones windows de gravedad o la muerte!If oil is needed, use American Eagle synthetic crack compressor oil (P/N C0087) or an equivalent synthetic oil.Check hydraulic flow and pressure.Lea y comprenda este manual antes de utilizar la herramienta eléctrica.Drain the condensation from the separator receiver until oil starts to come out.General Information To use the compressor, start the vehicle engine and engage the hydraulic system.Manifold valve stuck (closed).SRS-40 Manual 20 Problem Possible Cause Solution Compressor Stalls: Belt zawgyi Slipping.
Hydraulic pressure xd 40 manual safety and flow incorrect.
Then replace the drain plug.